contact_support
Did you find any incorrect product information?
Tell us so we can fix it. Thanks!Login for Price
Login for Price
- Brand: RehauType: 4-Wire
- The 4-wire manifold valve actuator is used to open and close circuit valves on the 1 and 1 1/4 in. PRO-BALANCE manifolds. Use REHAU thermostats to control actuators directly, or connect through REHAU electronic controls.
- Gray position indicator provides visual verification of the actuator's position|When the actuator is off and closed, the gray indicator is flush with the top of the actuator|When the actuator is on and open, the gray indicator will rise out of the top of the actuator and be visible from the side|Red pull-out tab is provided to allow easy installation onto the manifold, after installation remove red tab|A dry-contact end switch is built-In to the actuator|This end switch can be used to operate 24 VAC (2 amps max.) relays for pumps and other devices and can be wired so that pumps turn on only when actuator is fully open|If required, connect the green end switch wires to a suitable 24 VAC-powered relay to activate a device to be operated by the actuator's end switch or connect these wires directly into an appropriate zone control module|24 VAC "thermal motor" heating element melts a wax cartridge, allowing the actuator to open when there is a call for heat (power on), when the power is off, the wax cools and closes the valve (normally closed), operation takes 3-4 minutes|4 wires: blue/brown - apply 24 vac power, green (2) - end switch, length - 40 in (100 cm)|Low power draw: approximately 2 VA in operation, maximum 4.5 VA when first powered, ensures transformer has sufficient power (VA) to operate all actuators
- REHAU PRO-BALANCE Valve Actuator, 4-Wire, 24 VAC Supply, 32 to 140 deg F, For Use With: PRO-BALANCE Manifold